Harland Sharp Small Block Mopar 7/8" Shaft Mount Roller Rocker Arms, 1.6 Ratio Aluminum, For T/A Heads

Specs:
Rocker Arm Mounting Style: Shaft
Self-Aligning: No
Rocker Arm Ratio: 1.6
Maximum Spring Diameter (in.): 1.500 in.
Rocker Arm Style: Full roller
Rocker Arm Offset (Intake): 0.500 in.
Shaft Diameter (in.): 0.872 in.
Shims Included: No
Rocker Arm Material: Aluminum
Rocker Arm Body Style: Standard
Rocker Arm Fasteners Included: No
Rocker Arm Finish: Orange anodized
Notes: For use with Mopar TA heads only.
Rocker Arm Offset: .500 in. intake, .000 in. exhaust

Fits:
1970 T/A Heads (.500 Offset)

Kits includes:
Rocker arms, shafts, spacers, hold down clamps, adjusters and nuts.

Special Notes:
Harland Sharp SB Mopar kits require taller valves. Approximately .100-.150 are necessary for correct geometry but sometime lash caps can be used. Needle bearing allow for more oil flow to the rockers. Oil restrictors may be necessary to maintain oil pressure. Rockers are designed for big lift cams requiring .100 to .150 taller valves. Rocker shafts are drilled to allow for 3/8 mounting hardware. Needle bearings allow for more oil flow to the rockers. Oil restrictors may be necessary to maintain oil pressure. Rockers are designed for big lift cams requiring .100 to .150 taller valves. Rocker shafts are drilled to allow for 3/8 mounting hardware. Rocker spring clearance is limited to 1.500 if more spring clearance is required, W2 Econo kit includes .775 offset intake rockers. TA kit includes .500 offset intake rockers.