Dodge Mopar Challenger 2015+ Hellcat SRT HEMI GForce Performance 4" Aluminum Driveshaft - Auto
GForce Engineering driveshafts are all aluminum, splined slip-shaft assemblies designed with a tightly fitted splined assembly that lets the shaft plunge in and out but also gives the shaft the ability to spin vibration free and with incredible strength. The splined area comes with a boot to protect it from dust and other road debris. All GForce driveshafts also come with solid core, heavy-duty U-joints front and rear.
*We have a ton of different options for driveshafts, so after placing your order it is always important to specify the vehicle, transmission, and if it is stock or swapped transmission, as well as stock or aftermarket rear end. Please also confirm clearance above and around the driveshaft before driving off.
Description
Each shaft is high-speed balance checked on some of the best balancing equipment in the industry. Each driveshaft is balanced at 7 – 8,000 rpm to ensure you get a perfectly balanced driveshaft and to eliminate vibration and NVH.
Note: These driveshafts do NOT use a CV joint. No CV means you don’t have an extra 5 lbs. sitting on the front of your driveshaft that puts extra stress and loads on the output shaft and seals. It also means you don’t have a CV joint that can wear or need serviced. Also gone are the rubber couplers that are found on the OEM driveshaft.
These new driveshafts only weigh an average of 17 lbs. An OEM shaft can weigh 24 lbs. and 28 lbs. That’s more than a 7+ pound weight reduction.
Each shaft also comes with our billet adapters for the front and rear. Each adapter is machined to positively locate in the stock 3 or 4-finger yoke (flange) for a perfect fit and alignment. Both the front and rear adapters bolt right up to the stock yoke or flange with the supplied hardware for a trouble free installation.
Features:
4” Aluminum Driveshaft
6061-T6 Aluminum Driveline Tubing
Splined Slip-Shaft Design
Solid Core HD U-Joints Front & Rear
CNC Machined Billet Adapters Front and Rear
Bolt-in Installation
Peak HP and Torque Increase
Reduced Rotating Mass
Increased Fuel Economy
Note: 4" Driveshafts may require some modifications to other components (i.e. exhaust or crossmembers) in order to fit properly. Clearances can be tight and will vary from car to car and model to model.
TREperformance is an Authorized Priority Dealer of GForce Performance Engineering.
Shipping Information
- Item Requires Shipping
- 20.0 lbs.
- W65.0000” x H6.0000” x L6.0000”
- Free Basic Shipping
- This item ships in its own box.
- TRE Performance Difference
- We're the ExpertsAsk us anything. We are the professionals!
- Largest SelectionIf you don't find the part, we'll get it for you!
- Have a question? Ask the Pros
- Email UsGet answers from the pros
- 877-514-9494Mon - Fri 8:00 AM - 4:00 PM PST